Application

• Double smart repair cell, intended for the treatment of urban shocks in automobile bodywork.

Description

• Equipped workstation able to receive 2 vehicles on which alternately preparation work (sanding, puttying, infrared drying) for spray application work (primers, paint and varnish) and drying by hot air convection is carried out.
• Because of the different applications and in order to comply with the regulations, this equipment was designed and built on the technical basis of a paint booth with additional equipment for tooling and energy distribution allowing sanding, grinding and infrared drying by portal or by trolley.

The unit is therefore equipped with a single ventilation device allowing :

Preparation phase :

• The 2 zones are ventilated at half-flow.
• Painting is prohibited (switching off of the specific compressed air network for painting).

Primer or finish paint phase :

• Only one of the 2 cells is then ventilated with the entire air flow from the ventilation unit.
• Infrared drying is then switched off over the entire area.
• Sanding and grinding operations are also impossible.

Drying phase :

• The 2 zones are ventilated at half-flow
• Painting is not permitted
• The 2 stations are ventilated for a drying cycle by hot air convection with recycling at 60°C.
• Infrared drying is then switched off over the entire area.
• Sanding and grinding operations are also impossible.
• Painting is not permitted.
• Hot air drying is also possible (without infrared), allowing larger areas to be dried than with infrared alone.

Advantages

• Option to dry 2 vehicles during the same drying cycle
• Operator comfort and safety
• Reduction of vehicle return times to customers

Compliance

Machinery directive 2006/42/EC depending on equipment